DAVID SLS-2 Manual de usuario descargar pdf (Pagina 11)

3D Scanning

3D Scanning3D Scanning

3D Scanning

Menu “ Structured Light “

• Place scanner and object in front of each other, at the same distance like you did during calibration.

If the distance is too different, the projected stripes and camera image will be out of focus. A slightly

unsharp pattern projection is even desirable, but the camera should be perfectly focused. If necessary,

correct the distance between object and scanner, but do not adjust the focus rings.

Important: For each scan, observe that the red sine waves are not cut off / overdriven (this refers only

to the image regions where the wave pattern is visible). Should a correction be required, adjust the

“Projector Brightness” slider.

• Each click on “Start” performs a new scan.

DAVID projects a set of stripe patterns and records the images. This takes 2-4 seconds or more, depending

on the settings.

1 2 ... 6 7 8 9 10 11 12 13 14 15

Sin comentarios

DAVID SLS-2 Manual de usuario Pagina 11